Amp up your touchless wash ability with a system that works as hard as you do.
*We no longer include the 3 way valve within this kit, however it is still available right here if desired. *We have maxed out the value of Red-Line and M-Shine by now bottling them at 100:1 super concentrated strength, which means you can now get 4 times the washes out of this system! You will now fill your foamer cannons only 1/4 of the way full with soap and then top off with water.
Chem-X M-Shine and Red-Line combined on the vehicle surface create the ultimate touchless wash. These formulas are designed for everything from the most high end show trucks and trailers to cars, motorcycles, hot rods, RV's, buses and construction equipment. Our upgraded Touchless Foam Cannon Kit features the MTM Hydro PF22 Professional Foam Cannons.
MTM HYDRO PF22 FOAM CANNONS:
The Innovation of the PF22 Foam Cannon lies in the nozzle. This foam cannon offers not only adjustable fan blades but now offers an adjustable spray pattern (vertically or horizontally) as it throws thick foam onto your vehicle, house, fence, sidewalk, roof or other washable items. The chemical injection knob on top allows for more or less chemical to be drawn through the internal chamber, increasing or decreasing the foam output. This allows the internal agitator to create a dense foam.
MTM PF22 Specs:
Adjustable Chemical Injection Knob
Single Cast Plated Brass Body
New Ergonomic Easy Grip Bottle
Adjustable Fan Blades (jet-wide)
Adjustable Spray Pattern (horizontal or vertical)
Foams well between 1,100-5,000 PSI
Will work on 1.8-5.3 GPM power washers
Rated up to 140℉ water
DIRECTIONS AND TIPS FOR USING THE TOUCHLESS FOAM CANNON KIT:
Fill first foamer with M-Shine 1/4 of the way full, top of with water. Fill second foamer with Red-Line 1/4 of the way full, top of with water.
Set adjustment knob on top of foamers to minimum and then slowly tighten until foam starts drawing, this will conserve soap usage and frequency of refills. *
Foam M-Shine onto vehicle switch foamer and go directly over M-Shine with Red-line. Apply these foams in manageably sized sections working from bottom up. Keep in mind the goal of being able to rinse the soaps off before they have a chance to dry. Ideally each soap would have about 1-2 minutes of cling time before getting either neutralized or rinsed.
Once an area has been foamed with both steps begin a high psi rinse. When rinsing we recommend an up close rinse. We find it works best to rinse from the bottom up, by doing this you can use the foam line to keep track of where you have hit with high psi rinse.**
* Ideal strength is determined after seeing the results of the first wash, the goal is to use as little soap as possible while getting a great wash. Two things that help get an effective touchless wash are good soft water and also heated water up to 140 degrees if available.
**Try not to wash in direct sunlight as this will greatly accelerate drying. When washing mirror polished aluminum always make sure aluminum is cool to the touch before applying soap and never let soaps dry. If you are just off the road and you have polished fuel tanks avoid washing until tanks are cool.
- If using a hot water machine, scale build up from your coil can plug the foam filter. On start up always run power washer line clear before attaching foamer for about 30-60 seconds to flush out any build up.
*Remember to always wear your PPE (personal protective equipment)