Chem-X Foam Lance

The Chem-X Foam Lance was designed and hand built by Chem-X. We took the very best components and pieced them together in a layout with pure functionality and durability in mind. An almost fully stainless lance that is built to hold up in harsh environments. With this lance you can change between foam and rinse directly at the gun. Simply release the trigger and twist The Suttner ST-58 Change Over Valve a quarter turn to either rinse or foam. By far the best foam lance on the market!

1. Suttner ST-75 Foamer
2. Rolled Thread Stainless Steel Pipes
3. Sutnner ST-58 Roll Over Valve
4. 1/4” Male Thread

Apply foam and high PSI rinse with a single lance. Simply turn the ST-58 valve 1/4 turn left to rinse or 1/4 turn right to foam. 

-

FIGURE OUT YOUR CURRENT RINSE NOZZLE SIZE

Use the chart below to figure out your nozzle size. You will need your power washer's current GPM and PSI. This information is usually found on a sticker located on your machine.

REQUIRMENTS

• SUTTNER FOMING INJECTOR: ST-160 OR ST-164
• Does not include rinse nozzle but if you email or call us with your GPM and PSI we will gladly throw one in.

SPECS

• 14" length
• Stainless steel components
• Min/Max Flow Rate: 1-6gpm
• Min/Max PSI: 1000-4000 PSI
• Max Temp: 212 degree  *Recommended temp is 125-130 degrees