1. Pre-Wash First:

• Start with a clean surface for best results. Use Chem-X Old Glory, Stars + Stripes, The Don or another pre-wash to remove dirt, film, and grime.
• Rinse thoroughly before applying Snake Oil

2. Summon the Magic:

Apply a smooth, even layer, working from bottom to top, ensuring that no surface is left behind.

3. Let the Snakes Work:

Give it 30-60 seconds to bond. Don't overthink it, don't let it dry; leave it just long enough to charm the surface.

4. Rinse and Behold:

Rinse thoroughly with water, working from the top down. Water should bead when splattered, or sheet when using a controlled rinse.

• Apply Snake Oil to a freshly washed vehicle; either wet or dry.
• Apply in shade or on cool panels to avoid premature drying.

Foam Cannons: 25 Parts Water : 1 Part Snake Oil. Let the foam cannon cut it from there, tighten the knob.

Trigger Sprayers: 32oz Water : Quarter Cap Full Snake Oil. This bad boy can still produce results with just a drop.

Pump Sprayers: 1gal Water : 1 Cap Full Snake Oil. Go big or go home.

Power Washers:

• Freedom Foamer: Install 0.5 200:1 ratio tip, and pre cut Snake Oil 50/50.
• Standard Down Stream Injector: Pre cut to 25:1 before running through power washer.