Kona the Chem-X pup Ask Kona!

DIRECTIONS / TIPS / DILUTIONS

Directions
  • Pre-Rinse (Optional but Recommended):

Knock off loose debris with water.

  • Apply Eagle Guard:

Use a foam cannon, pump sprayer, or downstream injector to coat the surface.

Apply bottom to top for full coverage.

  • Let Dwell:

Allow at least 30–60 seconds of dwell time. Don’t let the product dry on painted surfaces.

  • Surface-Specific Tips:

Undercarriage Protection:
Apply generously to the undercarriage using a sprayer or undercarriage wand. Scrub with a brush if desired.

For maximum corrosion protectiondo not rinse off—letting Eagle Guard dry in place allows the rust inhibitor to fully activate and bond.

Side Panels & Painted Surfaces:
Foam on Eagle Guard, agitate with a mitt or soft brush if needed, and rinse thoroughly.

Even when rinsed, Eagle Guard will leave behind an invisible layer of rust and salt protection.

  • Final Rinse (if applicable):

Rinse top to bottom using high pressure. Skip this step for undercarriage-only applications if maximum protection is the goal.

Tips / Tricks

  • Pair with Snake Oil or Awesome Sauce for additional hydrophobic protection.
  • Use after winter storms or salty road exposure for ongoing protection.
  • For undercarriages and hard-to-reach areas, use an undercarriage sprayer or wand.
  • Use Eagle Guard as a routine rinse in winter months for best long-term defense.
Dilutions

MUST BE DILUTED FOR ALL APPLICATIONS

  • Foam Cannons: 4 Parts Water : 1 Part Eagle Guard
  • Pump Sprayer: 100 Parts Water : 1 Part Eagle Guard
  • Power Washer: Run at 100 : 1

*Note: If you're using a Chem-X/Suttner Foam Injector, it automatically dilutes at 100:1. Just place the pickup tube into your gallon of Eagle Guard and tighten the Chem-X Flow Cap—the injector does the rest.